Click for Walker Click for Westport Click for Fendertex Click for Abeking Click for Ocean Alexander

Twin Throttle cable adjustment

Discussion in 'Chris Craft Roamer Yacht' started by irwindustro, Apr 24, 2012.

You need to be registered and signed in to view this content.
  1. irwindustro

    irwindustro New Member

    Joined:
    Jan 29, 2012
    Messages:
    7
    Location:
    knoxville, tn
    I recently finished installing a new starbord engine in my 1964 36' Roamer and need some instruction on how to properly adjust the throttles levers into sync.

    I took the top cover off of the throttle lever assembly and there are 4 screws, not sure how to proceed? Any suggestions will be of much help. :)

    Dusty
  2. dsharp

    dsharp Senior Member

    Joined:
    Aug 23, 2009
    Messages:
    240
    Location:
    lake jackson, tx
    If they are Morse control heads The 4 screws are stops however the cables/ or linkage may cause the levers to stop before they get to the screws at max opening. I would get the levers close by threading the end fittings. The screws really don't do much