Click for YF Listing Service Click for JetForums Click for Northern Lights Click for Delta Click for Cross

Tender setup? Size??

Discussion in 'Post Yacht' started by PtJudeRI, Dec 16, 2018.

Page 2 of 2
  1. jrp4783, Dec 19, 2018
    #21
    jrp4783

    jrp4783 Member

    Joined:
    Sep 2, 2010
    Messages:
    61
    Location:
    Detroit, MI
    Good eye! Yes - Old Club
  2. PtJudeRI, Dec 23, 2018
    #22
    PtJudeRI

    PtJudeRI Senior Member

    Joined:
    Dec 1, 2010
    Messages:
    156
    Location:
    Pt. Judith, RI
    So measurements taken yesterday. From the raft to the aft edgeof the pulpit is 13'6". Width is no issue at 12' inside the walk-around. So I'm thinking that the tender can only be 10-11' if I want to keep my liferaft where it is? How much length does the motor up usually add to the tender?
  3. cleanslate, Dec 23, 2018
    #23
    cleanslate

    cleanslate Senior Member

    Joined:
    May 29, 2018
    Messages:
    1,661
    Location:
    Cherry Hill, NJ
    If you get and inflatable rib boat, none to little...the boob tubes, or tube ***** ( that's what I call them) :) will project as far or further back than the motor. If you have to tilt the motor up at bit to load then 8-12'' perhaps. Then again maybe none at all. Depends on the chock height/shaft length.

    If you find the older clean 11' Whaler, which is the one you should find/get, then around 10-16'' with a 10-20 Hp motor.
Page 2 of 2