A stuck by-pass valve will cause excessive oil pressure, or a spun cam or main bearing sometimes also. You have to drop the oil pan to access the...
The other ones, are just like installing a thru-hull in the boat. You drill the hole, seal the light assembly with 5200 and tighten the nut on...
Installing dual Racor's on a 62' Predator is not an option, unless you want to mount them 20'+ away from the fuel tank and engines. There is NO...
A sunseeker I run has 1100 MAN Common Rails and has no primary fuel filters whatsoever. They are relying on the 2 MAN filters to filter the fuel,...
Yeah, I'm pretty sure they're based off of the 3126. They seem to do ok.
I like the normal Racor thumb screw for safety reasons. I've seen many people bump the petcock while in the engine room and dump many gallons of...
And usually the broker splits 50% of the commission with their brokerage house........
They both have their merit's based on the type of boat. Steel is heavy, but very strong and easily fixed comparitively speaking. On a long range...
No, chances are you have a Blob of Algae blocking the drain hole.......take a wire tie and stick it up there, wiggle it around, and be prepared...
I'm no expert on LED lights, however they do not like higher voltage. If you plug a 12 volt light into 24 volts, you can watch each LED pop in...
Chances are it's a bad shutdown sensor, either overheat, oil pressure, etc.....disconnect them 1 by 1 and run it and that will tell you which one...
Each one is different, and it depends on stay like a hotel room. Get a cruising guide for the Carribbean (I like the Maptech ones), then visit...
Garmin would be ok, and I would get the sounder on the plotter, I'd also get the small garmin just depth unit with it's transducer.......they read...
The unloading was delayed a few hours, but all seemed to go well and fast once they were ready to start untieing us.
The 62's were all built in Holland or most of them. The 58' I ran was built by Burger Yachts in Palm Beach under supervision of Striker. I was...
I heard today from another Italian Builder that Azimut laid off 800 employees yesterday. Can anyone confirm that?
The azimut was sitting on the bottom in the stern, the engine room, engines and generators all got flooded as well as everything electrical in the...
I used to run/manage/and maintain a 1991 58' Striker SF. What exactly is it that you're looking to know about them?????
Well, I think it will come back eventually. But I agree the economy, uncertainty about the future (major factor) and of course fuel prices are...
Yeah, I've got a yacht to unload off of it tommorow morning at 9am.....
