Where's the boat located. Refinishing entirely depends on the material of the cabinets. If they're solid wood, then it's usually as simple as...
The Welland is open to pleasure craft in June. You just pull up to a docking area on either end, to use the phone booth to clear Canadian...
The 8v71's and 12v71's are both stout motors and still last a long time. I'd say 5,000 hours is pretty normal. 3500 hours if they've lived a...
I know some manufacturers......let's say sportfish manufacturers......and right now they only break even on their smallest models.....and they...
It most likely works and was cut by the previous owner, because the light is very bright at night......re-connect the wires and I bet it works.....
I agree, Bennett is usually very good about standing behind their products. I have seen thousands of trim tabs that were bottom painted and don't...
+2 I agree wholeheartedly
The results would be amazing using traditional compound, traditional swirl mark remover or finesse, and traditional wax over using just a...
If the doors on the other side are water tight, it's ok to leave it open. But, I still wouldn't think it's too wise to leave it open. If a wave...
He surveyed a 68' Azimut MY that I managed and maintained about 5 years ago. He left the boat and left the entire boat tore up. Every piece of...
I worked on one briefly a while ago, and it appeared to be built fairly well structurally. However, whoever did the engineering for the boat...
If the rollbar is stainless and was welded, it will always have re-occuring rust stains because of the welding. When Stainless steel is welded,...
If you know how to properly use a buffer, you should never get swirl marks. I never do. Swirl marks are usually from using too much speed, doing...
My statement didn't say for the yacht owner to crank the rpm speed up or down. I was explaining that the factory could change the generator rpm's...
Their website does not say. But it's the "whink rust stain remover" in the medium brown bottle
The hull is unfaired and very commercial looking......with the welds and plates showing so much
To answer your question about frequencies. Europe uses 50hz for their electricity. The US and CANADA use 60 hertz. They're not interchangeable....
They'll get what they deserve somewhere down the line. Do that in some of those smaller islands in the Carribean and they'll end up getting...
MASE generators run diesel Yanmar's and are run at 3600rpms and 3000rpms for 60 and 50hz. Fisher Panda also run's those rpm's on a lot of them. I...
This is very common on a lot of the smaller generators......I think they do 2100rpms and 1800rpm's on some of them as well to get the different...
