Rather sux that my forum has to post a link from the left side before I knew anything about this. Only reporting here from the local snews in Jax...
You do not need to connect a water heater to your engine. It's nice to have sometimes. Marine heaters come with / without this heat exchanger....
My new observations from those pictures; Aft door was closed. Design of after cradle trailer looked to be of one piece. In pic 23 & 47 you can see...
Yes please. ,rc
I have watched similar systems run in this mode perfectly. A maintenance or float charge is usually removed from the program when working in this...
S W, Delco and many others use a resistive swing. Mostly a shorted sender, the meter reads full or max. Generically called S W compatible. VDO Had...
Can you put a DVM over it and give us a resistive value? Also a report on how hot the new ones get after you install them?
correct 32v internal regulator part number is; 10474943 no jumper required.
hold on, maybe 24, be rite back.
delco part number
the small wire if there was external. I would recommend pulling the alt and sending it to a shop. If you feel adventurous, order and replace the...
the manual says run the engine to make sure the coolers are full of fluid. shut down. within a couple of minutes check the level with dip screwed...
Ah, The original 31SI Delco. Usually two cables to it. Batt + out & ground. Simple things on this model. questions; the batt + goes directly to...
UH? Leak down on a SBC? I guess that could be done. Keeps that clock going.. Lets hope again that's a broke valve spring. If the valve...
Then My understanding is, (maybe was) Detroits, Stewart Warner, standard equipment. Next learning question (for me); fuel level gauges VDO...
Problem?? The tech replaced the plug..
VDOs ? Humm.. I thought most old Berts used SW biased equipment. You're still Detroit powered? Please keep us updated. There is always more to...
12Vdc engine gauges with a resistor reduced common DC bus drawing from a 32Vdc supply. I’m not sure this is factory or how well it works. These...
K1W1 & SeaEric have passed precious information. You are the third wise man in this post in following their guide.
I'm no where close to smart enough to offer the science and math to explain. However, thru my years, I have read, heard and experienced a narrow...
