You'd need to weld a vertical member to the base that transfers that rotational load to the primary rub rail a couple of feet below your install...
When your vessel is too large to get into the marina, make your own.
My Technicold chilled water air handlers have an option for a heat strip to be added to any air handler. The control will call for that heat...
Yes, never chemicals. Compressed air is much more useful and safe.
Previous owner of mine had the yard fare and repaint the boot to dress her up to show. They fared over the heat exchanger discharge for the raw...
Weird...gray water sharing black water would mean that every drain must have a wet trap. Sitting could cause a clog. Air. Snake. Both good...
Yes, I can see the need in certain climates and with someone aboard that doesn't tolerate cold very well. In this situation we'd be well served...
Agreed, the circulation pump is very often much easier and comfortable to access. But in my mind it does need to run continuously as while the...
Error is it’s hot out.
Yes, single circulation pump running constantly on its own circuit. Better to keep that fluid moving than to start and stop with the compressor....
I agree....those pans are such an easy design to get right, yet everyone seems to get them wrong. Even my Techicolds. Drains are around back,...
I've run without significant issue at 96v per leg. Mind you everything was hot, but it was running. Power service was supplied from a 13k to 208...
I use GOST as well. Boat Command, as mentioned, is a good and very simple system if your boat has connectivity.
But big condensation? Just curious as it seems they'd sweat a lot...
Monitor your voltage with a quality and steady load on the genny. You're looking for low voltage, dropping below 100 volts per leg. HVAC wants a...
1) run it at the dock under supply by the genny and see if the errors return. 2) run it at the dock under supply from the other genny. Does it...
Wait. What? There are systems aboard? Lol...I thought recently I would take away or two and create the outline of an "owners manual" for the...
You could use the boiler system to heat your chiller water if you set it up with a heat exchanger and a separate heating loop to drive the heat...
If you're only running the one chiller, that 52 degrees basically means that your air discharge is never going to be colder than about 72 degrees,...
On areas of high water flow, like HVAC etc, I've introduced a bronze tee in line of the hose just ahead of a heat exchanger or sea strainer,...
