Hi, A strange phenomenon called wear can cause a loss of performance in any mechanical item. It is gear driven and it is also what is known...
Hi, You will answer your own question when you determine the fuel pressure. A split nozzle would likely knock off more than 200 rpm. What is...
Hi, I hope you are having a joke here and have not entrusted this project to someone who you have no verifiable history of and have accepted e...
Hi, A classed genset should do 110% of rated load.
Hi, Does your "rep" actually have some operational yachting experience? That is a very misleading statement There have been many yachts...
Good effort but it doesn't do much unless the offending one is resized.
Hi, Does this look like the stuff you are looking for? PEX Information If so it is available here as indicated by a post above...
Hi, Does the voltage go up when you rev it up to cruise RPM at the dock? The alternator doesn't know if you are underway or not as its function...
Do you happen to have a link to the article? Tried Googling it but didn't find anything.
Yes, I posted it earlier
Dunno, It is just nice to see when these boats change hands that the new Owners take care of them with improvements/repairs etc,
Hi, Where did I state he was travelling by boat?
Hi, Does your engine get to this pressure at either state? 50-70 PSI at 1500 rpm underway will be a much better indicator of the pumps...
Hi, It will depend very much on which CAT engine drives it. Some of the smaller ones have a very poor reputation while the bigger ones are...
Hi, No, note I said nearly 100 Gal a minute. We can load around 25,000 US Gal FW
Hi, That is the ex Reverie, good to see she has a new Owner taking care of her.
Hi, Maybe he ran out of gas on the way to wherever he was headed. Last Activity: 08-11-2010 07:29 PM
Hi, This probably works when you only carry a few hundred gallons, I don't know if we have either the space or budget for machines that can do...
Hi, Something around 1/2 that would work just fine - They already are out there.
Hi, Any of the manufacturers I am familiar with will also provide this service at cost to the end user so the savings need to be determined...
