You may also want to consider a 64' Pacific mariner in your search also......
It was during the POD craze when every builder was building a pod boat, it was all the rage at that time. BUT, at that time, all you could get...
I don't like the OA's of that era due to their seakeeping traits and lack of perfomance for their power. The 3412's are 12 cylinder CAT's and...
The only other manufacturer that comes to mind with that issue is Azimut, it started happening around the late 90's. Azimut quickly switched to...
The 63' Hatteras would be the best of the bunch. They did make a few with Cat C18's, which would help considerably with the fuel burn both at...
I agree with all this and add that they made a name for themselves as having shallow draft and being efficient. The big caveat is they never...
Standing in a 29' CUDDY CABIN mako to cross the gulf stream to Bimini? There isn't even a place for 20 people to stand on that boat, let alone...
Illegal immigrants are just THAT, ILLEGAL. Many times they're escaping their world, because they're a wanted criminal in it. Either way it does...
Are comments like these really necessary? Do they add anything to the forum?
That looks like it's factory installed. I would guess you'd have to have someone make one out of fiberglass.
Agree, it's too difficult to estimate cost without boat/pictures etc. But It's a pain in the ass of a job even with good access. Sometimes you...
I surely hope they didn't sell that boat to anyone!!!!
Also, I believe Joule transport moved a lot of them.
Those 29' Mako's had an issue with the engine/swim platform area of the transom cracking. But 20 people on a 29' is way too much weight to begin...
Load could be another one. OP could put them both in reverse in a safe area and see if it does it in reverse, and also look at the throttle % in...
Yes, the 44' HTX was shipped as shown in the picture in post #3. They were shipped all of the way from CA to FL without any issues. The 52'...
They'll do the same thing at idle out of gear. One way to check is to scroll over to the load/throttle page, make sure both of them are reading...
No, have to be in gear at idle speed to access synch. Unloaded idle does not allow synch. OP's boat is of the ERA that the MAN controls had...
Kevlar can be a very good material. But I always head impact resistance wasn't it's strong suit. That being said, kevlar is very noisy,...
Could be the start of a control head issue. Put them in sync at idle speed, what RPM's do they read then? Mapism- On the common rail mans, they...
