Do you have access to seasonal relocation mitigation to lessen the risks for the underwriter? Ie, Florida waters has the north-of-Savana-River...
Agreed, in that my mains and genny's all function with sea strainers but fed from similar screen wedge coverings. I installed a bronze T in my...
Try to time your diver with a shut down and avoid pulling up all of the crap he shakes loose. I'm not a fan of your direction, bit to each his...
more or less this is our regular routine on 12’s.
I have DD, but not the 6. Our procedure is to remove all pencil zincs. shut down the raw intake, plumb the zinc at the water pump intake to a 5...
Two degrees can be the difference if already stressed by hot seasonal water. Only one unit is tripping? I'm still in the camp staring at your...
And all three coils are reading the same, all three coils sit on the same plane of installation?
...but in the end I think you'll find that your breakers are fine, guilty of doing what they were designed to do. Mine as well.
...and I'm telling you this as much as I'm asking, learning here. My issue was very similar to what you're explaining, it seems, and mine was...
Ok, so different source, but technically the same issue driving the breaker trip. The breaker is tripping to save your gear, and the amp...
Ok, so after a thorough Red Line cleaning of strainer, pumps, and coils...I see lower discharge temps with the heat gun, lower amps on each leg of...
Ok, throwing this out there, as it's a new issue for me as well. One of my units is tripping the same breaker. It will run for a while, but...
I agree that Id pick the first one. That heater is designed to get hot, handle the temps. My guess as well is that the heater failure lead to a...
I use the same breakers and just recently replaced one that had gotten hit with some salt water from the water maker tantrum....
You want to go with the SP. Supplementary Protector, designed to provide additional circuitry protection for sensitive electronic systems, like...
I doubt it was related to "electrical" versus "cooling water". Chillers are very sensitive to their need for cooling water. Keep that system...
I had similar constraints. Old one piece unit with out via sawzall. Bosch 300 Series in two pieces came back to replace. The 300 has a 23.5"...
Look similar to what I have seen for SpaceX communications.
Agreed. That's what my eye sees here, much more of a rotational load issue than a down force issue. Although the down force is still a...
You'd need to weld a vertical member to the base that transfers that rotational load to the primary rub rail a couple of feet below your install...
