Assuming cable length dos not affect calibration, can you relocate the wires instead of the sensors ? extend the cables, temporarily ?
I learned on a Nacra 5.2. Fast and fun.
See if you have voltage right at each pump
Lenco makes them for alot of engines. Lenco coolers dot com.
That's the ticket.
When you goog-a-late the DD-751-WOC it comes up as a 750 watt unit at 120 volts which draws about 6.25 amps.
Nicely done.
This PT Boat was at our marina for a while. It had been used as an oyster seeding boat out of Tilghman Island at that time and had a pair of...
Another thought, is the "C" terminal hot ( 12 volts ) when the breaker is connected to the # 1/0 cables. In other words does the 1/0, when...
I see the "C" termination is a spade connection on the bottom of the breaker. You said it was " a lighter gauge positive" connected there. Does...
I interpret the shut to go to a meter expressing current draw of the windless in either amps or percentage of full load current depending on the...
Thanks, that's the P731.
Here is a link that will describe your breaker better. Then compare it to a Bussman equivalent, if one exists....
Pascal, did you get the P737, hand held like a drill or the P731 with two different hoses ?
I wonder if the Nigerian authorities searching for the yacht are the same Nigerian authorities that I correspond with regarding my up and coming...
Who'da thunk it !
And don't fall in love with it before hand.
Me too on 50's . I usually blame it on the corrosion of the outlet of the transient slip. I have had problems with molded 30 amp plugs not...
Just curious. Could you tell if the manufactures were different between the inlet ( or outlet ) and the cord end ? I have had a problem mixing,...
