Thanks I've been back flushing each unit as well. Unfortunately I have to pull the hoses off in order to do it and it does take me a while. I...
Thanks a lot Ralph for your helpful information. The configuration is the 46 post 1991. The system has two Cruiser air conditioning systems one...
Thanks. I was trying to come up with a solution when we're not close to the boat. The fresh water is pressurized as you know.
We do that. They only help for about 10 days here. Water is too hot and not moving well. Thanks for your nowledge.
That wasn't helpful.
I'm paying for the the recycled water. I was asking if you know how to do it properly not where I get the water.
I'm thinking of adding a fresh water intake to the Air conditioners. I'm tired of cleaning the strainer and heat exchangers in this hot, nasty...
Very nice job!
Understand. Both ways should work. I was afraid that I would flip the switch in the wrong direction, so I left them both full.
Don't bleed them plug them with fittings.
91-46. Post carpenters were very talented. My access is at the backside bottom of the bar below the microwave. Pemove the small panel, reach up...
91-46. Mine is a little different. I have one fill cap in the cockpit For both tanks. No check valves in the fillside just the T to both tanks...
Mine are as you described. No rudder or shaft zincs. Everything protected by divers plate. Anything that touches salt water must be bonded.
Amazing space!
How do you keep the rubber mats and laminate in place for engine room hatches etc? Can you use some 3M sticky glue?
Thanks. No trace of leak while filling. Only when just full One of the guys know about this. They'll post something next week. Thanks
The sender unit is on top of the port tank just behind the engine room wall in the cockpit. It is leaking pretty bad when we fill the tank. I...
Yes. Short Phillips. Pull up and sideways. SLOWLY BEND IT OUT.
Bow rail stanshion screw or toe rail screw?
