It's a 2006 RAW WATER PUMP that usually have a lifespan of 2.5 years, it's well overdue.
It's done, replace it.
Weight and expense. Steel is not an end all of all end alls. Get a little water in the fuel and they can rust, sending debris to the motor. It's...
I'd get it out of there now. Nov 1st is pretty late, especially to by dallying around. I'm available.
20 gph. Question is too vague, what rpms/load is it running at?
Post a picture of the breaker. If it's an ETN, you push in with a toothpick or something and it should pop out.
It shows you the coolant level at a glance since the heat exchanger cap is so close to the ER ceiling. It also does look like wires come off of...
Water heaters are known for filling up with scaling as they get old. 25 years is WAY OVERDUE. So yeah, if you want to waste time and money...
I would guess that your 25 year old water heater is full of sediment and junk, greatly reducing it's capacity. I'd buy a new water heater given...
Easy, get a flat putty knife under the side. Or easier, remove a light and stick your fingers in there and pull.
$30k is about the right amount for insurance to cost if it's for the correct value of your vessel.
I've found that everything bolted to the MTU's are cheap quality......starters, alternators, pumps etc........that and the millions of alarms that...
I was just in Nantucket (Sept 6-8th) right after this unfolded. They did a "welfare" check on the vessel. The Captain was onboard and assisted...
If you only have 2 INCHES of clearance you need both hands to remove the cap, 1 to push it down and the other to grip the sides and twist it at...
I'm trying to tell you WHY the gauge is in there in the first place. Quite honestly they are very common and I've managed or run 100 different...
Try measuring it when the motor is still 140F from last night, hence the gauge and no need to keep taking the cap off on a multiday delivery....
Look at the pictures. The engine room ceiling is 2" (51mm)above the heat exchanger cap, you're not getting a stick in there. This is very common...
The mid 90's-2006 54' Hatteras is an animal. It is an excellent riding sea boat and build quality and fast. I ran one (a 2004) with a tower a...
Well, IF you happen to look at the pictures posted. The heat exchanger cap is 2" from the engine room ceiling. So the gauges make life a whole...
The tanks are aluminum on a 1988 54' Bertram. 2 in the front of the engine room in a good location (high above bilge water and not near ER...
