I always use epoxy. West System with 404 high strength filler in this case
And it changes on its own for no reason. When it does, there will Be a warning symbol in the lower right corner of the chart
It doesn’t absorb water but I always roll a couple of coats of epoxy whether above or below wl
If only it was just the daily mail… Journalism is dead, replaced by mass indoctrination tools that would make Herr Goebbels proud.
You just run the wire thru the Coosa as if it was the hull and then in a groove behind all full of sealant
you can use a strip of 3/4 Coosa about 1” wide with a groove for the wire to be recessed in.
That must be a first for Nantucket.
No, the system is designed to use one or both cords at the same time. The control power switch (center) selects the cord used if only one is...
Failed 2021 generator?? Yikes. What brand and what was wrong. Can’t believe there was no warranty
Most appliances on your boat should be marine anyway. Problem occur on bigger boats with home fridges, freezers, washers etc although in think...
Three phase fives me a headache everytime I think about it. I know we were pulling from both cables because the meters on the cord selector...
N and G should never be bonded on the boat except at the generator and at the inverter when in use. This is why it s critical to use a marine...
Having an isolation Transformer is really nice and honestly I m surprised you have one on this boat. Have you actually seen them? I hope your...
I would not put a 50 amp connector on a 30 amp cord. Keep the pigtail, just replace the 30 amp plugs. You don’t need special splicing kits,...
Myers it all shuts down when one breaker trips on the dock. As long as both cords are 3 phases or single phase, the system will do its thing....
I looked at my notes, the 480 has three hots and a ground. No neutral. I have 480v between any two hot and 270v between the arch hit and ground...
yeah, that’s what i m wondering. With both 3 phase cords active, I have 214 v coming in the Atlas with 0 load as we re on gen.
We have two power cords, both originally with 5 pins 208 connectors. When we brought the boat to our home slip, I replaced one of the connectors...
So two 208s should provide more amps than a single 480? Isn’t 480 three phase? our gens at 45kw and never trip (never had to run both) so...
When connecting to a 50Amp with a splitter to twin 30s, the pedestal breaker isn’t going to trip but if you pull more than 30amps on each cord,...
