No but a Mercury analog smartcraft tach with the little LCD screen at the bottom will give you GPH and the information you're seeking.
I'd renew, you never know, you might get bored and come across a nice yacht delivery for a week or something and that alone more than pays for the...
Hydraulic. But your pivot tube on the outboard might be seized with old grease.
It needs to be rebuilt. Send it to a real turbo shop and have it rebuilt before it sends vanes through your engine and you're looking at a rebuild.
Also, if a raw water impeller goes bad and engine gets hot, the exhaust will cook the inside of the exhaust hoses and cause them to fail earlier....
7-10 years is the recommended interval.
No emissions rules. But anyone could have a Limited Liability Corporation set up cheaply, purchase the boat in that, pay $18k maximum in sales...
You can do that if you set up a Florida LLC and have the boat ownership in the LLC, register the boat in Florida, etc.
They didn't repower the 2021 with a gardener, they built the yacht and put in a used Gardener. Who on earth would build a new boat in 2021 and...
There is no CE spec for a Gardner, they were way before that and no way they'd pass any sort of CE emissions. They're very good motors, but as...
It's been a long long time since I've messed with Hynautic but I believe the filter is in this piece and is cleanable. Hynautic Reservoir Filter...
In your canister is a S/S mesh screen, it gets crap on it and restricts fluid. This is what is causing stiffness in all controls.
Without knowing anything about the hull, it's impossible to say
over 45 mph I'd remove it.
"Though the teredo is not a worm at all but a bivalve mollusc, it is only one of many hungry little vegetarian creatures which love nothing better...
The inspectors i see, all tip the dry chems upside down and bang on them with either a rubber hammer or the base of their hand several times to...
There are so many factors that go into the cost, was all previous maintenance done, actual engine access, drive time to/from dealer's shop, etc....
The only quote that matters are the ones in your area that you would trust to do the work, call them.
The purpose of the worm shoes is SO THAT IT GETS EATEN, and to keep the worms from eating your hull. Put a proper wood worm shoe and bottom paint...
It's mounted under cockpit deck, a very salty environment. Salt and aluminum don't mix. As for coring, Bertram had coring issues their entire...
