Thanks for the list Cleanslate, I will be checking both engines. Thanks Capt Ralph for asking about Port/Starboard, after doublechecking I...
Coolant is coolant. SW is sea water.
I just got back from the boat. Most of our time was taken up on another project that took far longer than expected. I shouldn't be surprised....
I will be on the boat next week and will post some new temps.
Yep, that's my engine. That's the screw on the starboard engine that I bled. The port engine has a drain cock there.
I call it straight up, see picture. I put new coolant in the port engine last year and in the starboard this year. I used Walmart Super Tech...
Change of crew, I'm doing the temperature checks now. Wet Turbos Intercoolers See attached photo for thermostat Not sure what horsepower tune is,...
Temp is from gun on the coolant temp sensor. Note; A higher rpm will get a 5 degree difference at the coolant sensor. 6-71 Turbos - Port turbo was...
I have 2 DD 6-71's. The starboard engine runs at 180 deg @1500 rpm and the port engine runs at 181 deg at the same rpm. The starboard fresh...
Ok, I appreciate the feedback. Less cash & time has value if I can get it working right.
Originally it was part being used to throttle & shift in one control, but over 3 years the Hynautic system has not worked well. It was serviced...
I'm about to move forward with converting my Hynautic controls to electronic with a SeaStar/Teleflex KE4+ system. I've been thinking about it from...
I have a 48 MY with rocker switches for Ignition-Start-Stop. The lower helm ignition switch (on-on) is wired as a 3-way switch with the fly bridge...
My Ocean Yachts 48 MY has 3 rocker switches for each engine, On-Start-Stop. Can I convert to a key switch?
Update One Year Later: By the end of June last year, after many days and hours troubleshooting this issue, I had to move on to a more urgent...
January 2022 MarineMax - (NYSE: HZO) $2B Sales With only 3 months before the boating season starts, MarineMax general manager for Massachusetts...
Update: I had an electrician come down to the boat who pretty much reviewed what I've done so far and checked current on the shore cable, and...
Last Friday I bought 2 sealed bearings a little under 1" dia. and wasted about 3 hours total trying to make them work. I just ordered some nylon...
I assume you didn't find who made the door or track parts. Did you replace any of the rollers?
Good catch Capt Ralph; The A/C units in the engine room were mislabeled. The larger unit in the engine room is for the salon. So originally I was...
