Fixed it for ya' There’s a stringer wall in between the walkway between the two engines quite high so the boat could leak a lot of fuel or oil...
But that still doesn't say WHY the rear door was opened. From putting pieces together gives me the idea this MAY have happened. 1) Reports of...
I've done dock express from the Genoa, It and Palma, Mallorca, Sp. regions. Not familiar with any pickups in France.
Not sure if I'm allowed to mention another forum on here, but will give it a shot. Check out "Trawler Forum", it's populated with Jefferson and...
Come in all common sizes. Store MUCH easier. Again, internal flow is opposite of a pleated/spun filter. So either buy appropriate inlet/outlet...
I've used them on some boats I've worked on, and they've been fine. Other models of watermakers did not use them. Six of one, half dozen of the...
Why would you try a northern east to west crossing at all. That goes against all logic. East to west is ALWAYS a southern route. Hell even...
Ah, I missed that thumbnail pic.
Yes, there are many coupling manufacturers and many models of couplings. One style would be used if the engine/trans were considered "Close...
Not much, and I don't know how current any info is. https://yachtharbour.com/yacht/calypso-2033...
Needs to have UV/outdoor sustainability. I've had various, from white rubber thru silicone.
Yeah, I'd say a bit undersized too. For years I worked a 120' Tri-deck with those same anchors, but we were 450 lbs, 5/8" chain. The pic you...
Just MY opinion, Your Mileage May Vary Run Forrest Run!!!
Being an engineer on Mega's for many years I'm EXTREMELY **** about my tools. They how I earn my living and keep a reliably functioning yacht. I...
That begs the question: How do you cool the ASEA units when you are using the chiller loop to HEAT the boat in the winter? Most air handlers...
Off topic, but a few years ago ASEA was developing liquid cooled shore power converters to eliminate the high heat out put, and also allow the...
Yeah, probably some sort of isolation transformer. Hard to tell without seeing how it's wired into the system
I would leave "E" in place, just a good safety in case of a ruptured hose. Without it discharge line will seek sea level equilibrium. "C"can go away.
Way back in the late 80's I water skied behind what was, at the time, a well known high speed 115' charter yacht. We tossed around the idea of...
I've used the Arid units before. During the install/setup/operation I got to know the company principal pretty good. If I ever had an issue I...
