Congrats on your project. I have a 84 43'. My port tranny does the same thing but in forward gear for a second. Not every time and usually on...
You may also want to try Newport Marina: http://www.igy-newport.com/ See if there is space available on the inner basin. No waves in there....
I know you are looking for 46 performance, but I can tell you for my 43: I have 450 horsepower, you have 485. Same transmissions. Your boat is...
My 43 has a small inspection port in the cockpit floor over the sending unit. Previous owner must have put it in. I have taken the front tank...
Can't give you direct experience with replacing these. I replaced each of mine which are dry on 671's. But if you are still trying to source...
Thanks for the comments. For the most part, the only water I get is from the shafts while running. A little does come in through the anchor...
Any one having issues with bilge odor in the bow? No matter how much I clean with bleach, hang mildew bags under the floor, it comes back. The...
Just thought of one more thing if you try this. Swap the repaired hatch with the forward stateroom hatch so they will still match side by side....
It seems like these hatches were made from a resin poured into a mold. I have asked vendors at boat shows who make plastic parts if they could...
Yes, you have the 23rd 46 they built. This timeline: http://www.postyachts.com/a_pgs/pgs_prd.htm may help you. Your boat is 2-3 years into...
Looks great!! You should be really proud of the work. One picture looks like you replaced the side salon windows with a single piece or two?...
Boat looks fantastic!! I spent almost 20 years growing up on a 1975 42'. Can't remember the hull # but was in the teens. You will want to...
I like the stainless exhaust hood over the stove. I put in a stainless refrig and would love to match it. Custom replacement?
Installed and ready for summer Install went great.
1984 and no problems either. Are you aware of the drain for the fuel tank compartments? PVC pipe that comes out under the stairs in the bilge....
Update I initally wrote to Post and Ken Jensen got back to me with the original manufacturer: Riverside Marine, Riverside, NJ @ 856-461-1077...
I need to replace the aluminum exhaust joint\elbows in my 1984 43'. Not the wet elbow mounted on the turbo, but the 8"?? (haven't measured yet)...
I have a 1984 43' so they should be the same setup. The rear tank feeds the starboard engine as well as the generator. It is slightly larger...
This article has a very basic drawing of an older 42 you may be able to modify: http://www.boatus.com/jackhornor/power/post42.asp
Don't both with this. After a few weeks in the sun the rubber yellowed heavily. Doesn't match anymore.
