Saying all the "all in ones" are crap is a bit over the top, no? To the OP, I did not have a washer or dryer in my 42, but I have been using a...
I have a couple sets yet. I'll look tomorrow to see exactly what I have. The main sets I have are 1 3/4" but I also have an excellent condition 1...
When we traveled I kept two props on platforms I made under the rear deck, far corners of the stern.
I could feel mine move a bit occasionally, never botherd me though, since I new what it was. And not a single person ever mentioned it to me.
Mine were screwed down when we bought the boat and then for the first or second time I had to access them. After that never screwed down again.
I also used the Dri-Deks under the bed foam mattresses. We had the twin bunks on the port bow and twin bunks in the main stateroom. The Dr-deks...
I had two, one in the rear and the main one up forward in the bilge. The forward switch set off an alarm at the helm and by the salon entrance. I...
I have a set of S&S Katapult 4 blade props, 24x24 IIRC Have a 3 blade set as well, not sure of the size though.
On my boat (no longer have) I had a cushion that went all the way across that bench. I kept DriDek tiles underneath it to allow the water to...
On my 1980 42 it was up front under the forward berth. Above and to the port side of the main bilge pump. It also operated a high water bilge pump.
Power Cool - Penn Cool
250 or 750 ? That thermostat is 100-120. Personally I think that is a bit high.
1500 watt heaters with t-stats makes a great combo. My t-stats were on (approx) at 50 off at 80 degrees. Heaters were in the side of the block and...
I had J&T 6-71 TI with Capital gears. IIRC, mine were: 1 in the trans cooler 1 in the discharge side of the raw pump 1 in the fuel cooler 2 in...
OK, for some reason I thought you had turbos. Your naturals are J&T's?
Take another look at my elbows. I really think they are an ideal configuration for the water inlet....
I only did the rudders because one of the originals spun on the shaft. I don't recall the exact makeup, it was either: Bronze rudder, stainless...
It looks like I did the work in 2002 for about $1700, not including the rudder shelf I made out of fiberglass.
I really don't recall. But, considering the amount of money and time spent, I'm sure I convinced myself at the time it was an improvement. I know...
Don't know the name of it either, but pretty sure i know what you are referring to. This web site has all kinds of rubber weatherstripping....
.jpg&contenttype=jpeg "Click for Abeking")