They're almost certainly NiBrAl. Michigan has changed their casting a lot of late and they don't look like the current version of the DQ's,...
33.4" diameter 43.3" pitch are the important numbers. Couldn't make out the prop shop label but looks like Bay Propeller, might try giving them a...
Without a schematic of the installation I really can't say unfortunately.
That would be hard to do without a lot more info; size, amperage capacity, voltage, type etc.. There are literally thousands of diodes available...
A lesson in how NOT to wire a boat? Looks like an isolation diode setup but has several things wrong. 1. Using aluminum as a conducting material...
I've used both the ones from Lewis (Scandvic) and IMTRA, both are very close to the same output. Make sure you get the warm white, cool white has...
If the builder used plenty of foresight and standardized the builds they may have used the same wiring scheme on the shop floor no matter where...
To Capt J's advice I'll add a BIG warning when you bar them over to make sure the stop solenoid (which also needs changing to 24V) is engaged! If...
Any way you can raise the atmospheric pressure behind the cabin will help to some degree but there's always the trade off with mist/spray when you...
An integrated deflector can have a positive effect. I've seen deflectors similar to what you see on the back roof's of station wagons or SUV's...
Many possible causes and solutions; Try dry fitting without the keys and marking how far the wheel goes up on the taper (without torqueing or...
AN exhaust leak can easily clog both engines intake filters but I'd bet it was simply a matter of overloading. Even though you were at normal...
That flip looked very professionally done, no excitement is very much the goal! On a much smaller scale here's a flip of a 41 hull speeded up,...
75' depth makes the 50's the best choice, I wouldn't agonize over that decision and if you expand your range the 175 will handle it if or when...
You do have the GT50M-THP correct? The detail they show of bottom structure is amazing compared to conventional sonar but I think you'll find...
In the one off custom world that 65 would take anywhere between 16 months to three years depending mainly on interior complexity. Production yards...
My humblest apologies Carl (or whichever mod caught the too large picture size), I wasn't paying attention and mistook file size for the pixel...
Rich could most definitely meet those numbers with conventional shaft drive! As you know, interior accommodations of a SF are meager compared to...
If you have an R series compressor all evaporators will have to run at the same time and fan speeds are paralleled, both units will run the same...
Should work just fine!
