I've recently purchased a GPS guided satellite dish for my Carver, but I'm having a difficult time following the existing wiring channels to run the wiring for this piece of equipment. I don't want to drill any new holes in the inside structure if I can help it, because I know that could open a whole new can of worms. Can anyone help me find a diagram of where the factory wiring runs so that my own wires can run in tandem with the existing wires? Or at least a phone number, or some contact information for someone who might be able to? Thanks in advance.
you dont specify model, if it is 4207 the wires go from stbd side ER up to the Bridge deck under the seat. Remove a black panel acessable from stbd after opening the rear salon window to see wire route.
