Click for YF Listing Service Click for Burger Click for Delta Click for Westport Click for JetForums

Hatteras 41 parts ( Sportfisherman) 1967

Discussion in 'Technical Discussion' started by Rafaeldelgado, Dec 26, 2014.

  1. Rafaeldelgado, Dec 26, 2014
    #1
    Rafaeldelgado

    Rafaeldelgado New Member

    Joined:
    Dec 15, 2014
    Messages:
    2
    Location:
    San Juan
    Where can I obtain an original driving console for a 1967 sportfisherman Hatteras 41 for the flying bridge
    ​
  2. Capt Ralph, Dec 26, 2014
    #2
    Capt Ralph

    Capt Ralph Senior Member

    Joined:
    Sep 8, 2004
    Messages:
    13,651
    Location:
    Satsuma, FL
    There is a company that removes these old consoles and installs new updated modules near the Old Hat plant.
    Most of the new stuff is custom but the old stuff must get piled up somewhere.
    I read about them in PBR mag long ago. Maybe someone here on the thread can come up with a company name.
  3. TeKeela, Dec 26, 2014
    #3
    TeKeela

    TeKeela Member

    Joined:
    May 1, 2012
    Messages:
    151
    Location:
    NC & Puerto Rico
    Slane Marine in High Point, NC does restorations and has some of the old molds for Hatteras.

    Tom Slane is Willis Slane's son. Founder of Hatteras.
    Last edited: Dec 26, 2014
  4. Capt Ralph, Dec 26, 2014
    #4
    Capt Ralph

    Capt Ralph Senior Member

    Joined:
    Sep 8, 2004
    Messages:
    13,651
    Location:
    Satsuma, FL
    That's them.
  5. TeKeela, Dec 27, 2014
    #5
    TeKeela

    TeKeela Member

    Joined:
    May 1, 2012
    Messages:
    151
    Location:
    NC & Puerto Rico
    If you are in PR, and just need a console and not doing an original restoration, I would have a console built to fit my height, controls, electronics, etc etc. It's a good time to do some upgrades. You would have to get the thing shipped from NC.
  6. Capt J, Dec 27, 2014
    #6
    Capt J

    Capt J Senior Member

    Joined:
    Jul 11, 2005
    Messages:
    14,611
    Location:
    Fort Lauderdale
    I would agree with this. A console should be a relatively normal/easy thing for a good fiberglass guy to make.
  7. Capt Ralph, Dec 27, 2014
    #7
    Capt Ralph

    Capt Ralph Senior Member

    Joined:
    Sep 8, 2004
    Messages:
    13,651
    Location:
    Satsuma, FL
    I did not notice the PR address. Then, the shipping to PR would be a killer. Even I would look for a local glass man.