You might want to flush raw water cooling system, change raw water pump impellers, and when first starting engines be prepared for stuck injectors...
looking for front window glazing spline . I am resealing the front windows and the glazing spline needs to be replaced . Anybody know of a supply...
I would be interested in your used one. I am looking to put one on a 1981 46' Viking Thanks Peter Falkner
thanks for the info
I replaced the rudder shafts due to corrosion and I am in the process of replacing the rudder table. My question is what is the toe in or toe out...
I have a 1981 46' Viking conv . In the process of redoing all water systems (wash down ,supply and waste) Looking for advice on what pumps to use...
they are green
The specs say for engine serial # n90 with a no load speed of 2500 rpm . I think with the bigger injectors they had a lower rpm
Thanks for that link I looked at that website and saw that they were pins but completely missed that they were nylon I must be losing my mind
I have all tools required for Detroit, been a heavy equipment mechanic for 30 + years did use engine serial# to verify n90 injector
I need to figure out what holds the pin in that holds the cylinder to the tab and bracket
I have 8 injectors now my suppler only has 6 left waiting for two . I was hoping to change trim piston by reaching in water from dingy will check...
I think the props on the boat now are 3 blade 26 x 26 not sure if they are the correct ones. I could have a hp issue due to the fact that the...
I am pretty sure I purchased the boat you speak of. When I left Port Washington she cruised at 15 knots at 1700 rpms and hit 20 knots at 2000 rpms...
Just purchased 1981 46' viking conv. I am currently fixing mechanicals, 8v71t run excellent ,onan generator runs excellent but has generator...