Its the frig dude... I have never got more than 3 years of good service for a A/C - D/C frig. A Norcold or Dometic will do the same thing after...
Frig I don't care what others are saying? I have the same boat and paying the extra $$$ for a frig that runs on 12V is just not needed unless...
Hey everyone, Port muffler is making a clanging noise on cold start until it fills with water. could there be a broken or loose baffle? sound...
Look at these... We have the same boat...go to Summit Frig. we found one that fits perfect! keep in mind these are 110V only, some have backup...
Yes, these are the old zincs, but they put the new ones in the same spot. Shaft is not bent or twisted. I did not get rid of the vibration until...
Are These Zincs Too Close To The Cutlass & Strutt? Are they going to stop flow to the cutlass B? They put the new ones right where these old...
What would cause a turned shaft or need to tune the props if no damage and low hours 360 something
Don't use acid! I have similar Carver...Find a spray on coil cleaner on line you spray it on the coils, wait about 45mins and restart the system,...
Gear man did this today, he said if anything the starboard looked off not the port but he was riding with me and said it was for sure coming from...
By the way cutlass B are good no play and everything looks true. Do you have to tune props that have no damage? 368 hours.
I Think CAPT J has it... I think that's it, port shaft is slight out of round and the new larger and heaver zinc is aggravating the condition....
On The Sling Twice Today Pulled out, removed zinc and replaced it with another new one...Splashed it again and the vibration was still there....
Thanks for all the feedback, I'll keep the Danforth it's working fine...
Just splashed boat after bottom, zincs. Port now vibrates at 1200rpm and above. Ship yard will pull and replace next week. Ever heard of a zinc...
Thanks for the anchor advise I think you all are right, change is not always good, I'll keep what I have until I break it or loose it. Thanks,...
Have had a large Danforth Fluke for years and had good success. Wanted to change to a Delta Plow (fixed). Lake Lanier, GA. soft mud, clay and...
Call Me Maybe I Can Help When it hard I too get water in the dinette and the counter top in the kitchen. One time it was so bad the carpet even...
Me Too My 1993 Mariner with same equipment; I have found that I have to hold the start toggle longer than I would like. But I have noticed that...
There is a number on the lock, I'll need my glasses and a magnifying glass to see it... LOL Both of these are good suggestions, I'll look at it...
Have 1993 Carver 330 Mariner. Key is missing from the electrical panel. Any other ideas other than a $175.00 locksmith ? Thanks!