Epic fail :) So I get up the nerve and start my project: First cut the pilot hole to make sure I am not cutting through any wire, once done I...
Well, was at the boat today. I think I can do this. I used my flex camera to run up thru the radar arch and can see where the overhead lights go...
1995 Carver 355 [ATTACH] 1995 Carver 355 on Lake Lanier, GA. "Miller Time, part deux" Scott Miller
Agreed.... I have seen a pick like that before where a pipe burst or something like that that coats the boat in an ice blanket....amazed the boat...
I have a 1995 Carver 355 and am interested in running some wires thru the aft hard top for rear LED floodlights and to mount a rear facing camera....
I have thick skin and can take the jabs....but I knew this was an issue when I bought it. I have owned various boats over the last 25 years of my...
access To paint the picture a little clearer.... this is the only opening I have to access the front of the engine. [ATTACH] [ATTACH]
Thanks for the responses. It looks like there is more clearance with your mercruiser engines than are with my crusaders. I can just see it...
Thanks for the response. Yeah that was what I was afraid of. Very little clearance between the motor and the hatch supports. I will be hanging...
Thanks for the reply. I have done a number of impeller swaps in my past, however the forward part of the engine seems like it is almost impossible...
Went to change the impeller on my Carver 355 Starboard 454 XL and cant seem to find a way to access it. The clearance is just too tight to fit...
Ok thanks for that tip. I will look into that and see if that helps. The previous owner also said that the chain stacks up high in the locker...
I have a 1995 carver 355 with what I think is a stock windlass. Lately when I go to retrieve the anchor, the windlass spins but does not grab the...
If not getting juice to the relay, I would check the generator control panel. There is usually a circuit breaker for each leg of out put. The...
In a closet in the aft cabin in my 1995 carver 355 there are 4 coax connections. One is a new run from the coax input on the exterior of the boat...
resolved Ok so original issue was that I thought there was a blockage in forward holding tank vent line due to poor flusing and toilet water...
All, on my 1995 Carver 355, I have a sink/ice maker station on my aft deck. After being on the boat for a while, I have discovered that this is...
Sorry for the premature post. I found it. It is located underneath the aft bed.
I occasionally get a wif of gas odors in my adt cabin. Can any of you tell me how to access the rear tank for inspection? Thanks, Scott
Unfortunately no. I am not sure this boat even has filters now. I am concerned that the previous owner overfilled the front tank and now...
