Nope not sure
Ebay http://www.ebay.com/itm/like/222456090774?chn=ps&dispItem=1 Looks like this is it.
The steering is a SeaStar(teleflex) flexible helm. The Pump is located behind the steering wheel. This is behind the dash. There is no specific...
As others have stated you need to follow the lines to verify what it does. That said my best guess would be fuel selection for the generator.
Here is the OEM paint supplier for Carver. The paint part number is for my 2001, I was told that it was the same paint color for a range of...
Pickup attachments for removing and re-installing the hardtop.
My friend has a 2000 506, his boat has 24 volt engine starters. His bow thrusters were wired to the two D batteries that are the port engine...
Call the people at this link in Little Rock Arkansas. They will know the answer to your questions. They have been in business since before 1980...
Carver's published bridge clearance is measured to the top of the anchor lights, both models of carvers you are looking at will and have cleared...
I found the instructions on removing it. REMOVING THE COFFEEMAKER UNIT 1. To remove the unit from its mounting (for service or cleaning), first...
I believe that the coffee maker actually slides into a mounted bracket. Just left up a little maybe 1/8 of inch and pull it out, then you can...
I have owned 3 Carvers a santigo, 396 and currently 466 all three boats had the battery chargers bypassing the main battery switch and wired as...
I had a small leak that was hard to isolate last year. It also turned out to be the above mentioned O ring on the foot pedal.
Also, they are NOT the small rule shower sump units, but 12 to 15 gallon poly grey water holding tanks, that have rule 3000 pumps in them.
Hey, report back on how it goes. Mine is working great, but I know sometime in future, it would be nice to replace the whole mold assembly. thanks
I do agree, if it was from overflowing, you should see water in the ice bin or at least some water dripping down, immediately after a recycling...
here are some suggestions to check in regards to your current problem. Check these: 1. water overflowing into the storage bin then freezing....
I am curious also, did you replace the ice mold by running the compressor to keep the freon filled cold plate from expanding? Did that work for...