you and me :) I'll try and make it simple. Both S and P gauges stopped working at the same time. 2 gauges, 2 sender wires from 2 different...
Neither were working before the swap. But almost testing opposite when I jumped sender terminal to ground bus. Tried running direct sender to...
Neither work if in proper orientation.
Yes. I swapped starboard lead to port gauge and port lead to starboard gauge. Gauges read fine. Saddle tank 3/4 and day tanks full. Swap back,...
So i swapped sender leads. Day tank sender to port gauge-reads fine Port gauge sender to starboard side- reads fine why?
I attached photos of the back of my gauges, they are daisy chained to the volt meters (fuel gauges have yellow terminal connectors). On the...
Me….crawling around bilge and cleaning. Port sender is visible, I cleaned and checked connections. I cannot find the day tank sender.
I have a 2000 56'SS, I recently lost both fuel gauges at the same time. I don't believe it to be a gauge or sender problem, chances of both to go...
I'm not saying I'm an expert, I'm being a bit humble in the sense I am not sure I am describing the situation and trying to provide as much info...
I'm not sure, when I say bumpy/lumpy I mean there is a lot of play in the wheel. I can make a 3/4 rotation and the rudder won't turn. Then you...
I have an older Teleflex BA175-7TM hydraulic steering cylinder on my 2000 56' Ocean Yacht. I am experiencing very bumpy/lumpy steering as well as...
Replacing impellers on cats 3406e, typically used Sherwood but have come across recmar impellers that are significantly less. Anyone have...
I am not sure, being winterized and just recommissioned. I have replaced the governor actuator, governor controller and bridge rectifier. My...
Still had the same issues this weekend. Ran the genny while we cruised to our location (hour or so run), dropped the hook and got settled in....
I did clean up the ends although I did not replace. There is certainly no slack in any of those lines to allow for a new crimp. Won't be able to...
Well don't know if its good news or bad news but this genny does not have the optional voltage regulator (in the Westerbeke owners manual it does...
Appreciate the insight, I plan on starting to work on it tomorrow. I received the parts today and when I open everything up I will make sure all...
I spoke to Westerbeke's master distributor for our area and they directed me towards the voltage regulator and rectifier, I am going to start by...
yes actuator is the governor on this genny
Same thing happened this weekend. This time I immediately shut generator off once I noticed the high voltage. I went to restart and it started...
.jpg&contenttype=jpeg "Click for Abeking")