The Mariner's Museum is closed for renovations. I am seeking a wiring diagram of the 12 volt system for my boat. A fire in the wiring harness...
I am in the process of refurbishing the flybridge on ALGERIA. I would like to replace the clear spray screen. I believe the original tint color...
It's time for a bottom job and I need to supply the hauler the dimensions with and without the fly bridge. Anyone have the exact numbers?
I have owned this fine vessel since 2001. It is now time for her to go to a new home. Always a fresh water boat. I am only the 3rd owner. Work...
It has been 12 years since I had the carbs on my Roamer rebuilt. They are Carter's on my 427's. Does anyone have a resource to send them out to be...
Does anyone have a resource for a new starter for my 1968 427's? Or perhaps a quality re- build shop. My engine turns over but doesn't start,...
I have decided to sell ALEGRIA after 12 years of joyful ownership. My work involves more travel than ever. I am unable to use the boat the way I...
name plates If they are original for a 1968 37' Riviera then I'll take two also.
Name plate I would be very interested. Would you mind sending me a pic to my email? Lacabina2@msn.com Thanks Steven
My 1968 37' Aluminum Riviera on Lake Allatoona GA [ATTACH] [ATTACH]ALEGRIA On Lake Allatoona
The previous owner of my 1968 Roamer Riviera 37' AL installed a cheap dorm refrigerator 110v. I would like to find a decent unit for my needs. I...
Does anyone have a picture of the original striping on the flybridge of my Roamer-1968 37'. I would be happy with dimensions and location of same...
Nautolex installed, SS trim strips? Well the Nautolex install went very well. The stantions for the flybridge ladder are back from being...
Blowers I have the standard blowers that came with the boat. I always use them as well as the manual sniff test.
Air Venting Thanks guys. My thought was to maintain the air flow in the same amount as the original "box" designs. I am thinking maybe I'll even...
In the process of rebuilding the aft deck I came across the original "boxes" that were used to vent the bilge. These would be the ones that serve...
The last week I removed one cross member support joist for the aft deck. This joist, (as are all the others), was bolted to the aluminum frame...
Anodes and Cutlass Bearings My tech just informed me that he measured incorrectly for the phenolic cutlass bearings for my 1968 37' Aluminum...
thanks Thanks for all of the feedback. I was not present when the tech got them out but he did. yes I am replacing with non-metallic shell...
Any one have a good way of removing the cutlass bearings from the struts. The ones in there now are in a brass casing. This was a mistake and...