Has anyone taken the refrigerator out themselves? Want to remove the existing "home" unit and replace with a counter height marine unit. It...
4 - Cupholders big enough to hold a Yeti are hard to find. The teak cup holder that I had was much too small for modern thermal cups. I used...
There is a case of documents from the original owner. I had seen that one when I went through it to see what what there.
Panel in hallway, your height may vary depending on how the AC lines allow clearing the back of the sensor - g
Had the Tech from BOE come over yesterday. Ran through the setup wizards (I now know how to access them) and a fine heading adjust and the CPS...
Information post if anyone else is looking to add one. Just installed the LIST TM-322 multi-level holding tank sensor in our 1989 Post 43. The...
Strangely enough I have the installation instructions for it. Here is the wiring figure.
I finally found the AP IMU processor! It is located in the cabinet in the cockpit (the old Robertson IMU sensor is still under the lower bunk by...
Since I was under the helm wiring I wired in a manual over-ride switch for the aft pump. Have one on our Viking and have found it useful so added...
Thanks for the date. My wife requested to join the Post group on FB, I don't use FB. I'm on travel that week, will depend on when I actually get...
When is that? Planning to go to Cambridge for Maritime Festival the end of this month.
Did you get photos of the transom view of both? Would like to see the difference and compare to mine. [ATTACH]
Found abandoned cables from breaker box to helm (the old ignition arm switches) and repurposed one so now have a working aft bilge pump operating...
A little more checking and my boat must not match the wiring schematic. The line that it shows as bilge pump indicator light blue/black is always...
The aft bilge pump outlet on our boat is a good 6" above the static waterline. (The exhausts are completely out of the water as well).
I had a thought related to your question. When at rest is the forward end of the side spray rails above water on one boat and not on the other?...
That is what I expected but not what I am getting. If the indicator is wired to just the manual lead it behaves that way. When in manual the...
With help from board member Davidoc's terminal strip schematic I was able to locate the under helm connection for the (not currently connected)...
Sent you a conversation msg - Thanks
Look the same. Size on mine is 4-1/4" x 6-1/4" outside dimension.
