From my CMap mobile app. I'm assuming the CMap aboard is similar... [ATTACH]
How did the coconut fare?
Good place to leave it... I was just a couple of days ahead of him. Got a face full of front running to impact Bertha. It got snotty out there...
Please stop and consider what you just said above in bold. Once the varnish is laid, there is no opportunity for those end grains to get wet. In...
If the problem keeps recurring, there are but two culprits: considerable structural flex or moisture. Most often the issue is moisture, and...
You need to get to clean wood. That's all. Otherwise the epoxy, even thinned, is trying to adhere to the mold/etc and damaged end grains.
Not if you can eliminate the introduction of moisture to the situation.
Moneyball, "Adapt or die". Evinrude was in a terrific position to strongly dominate the market, but the forks in the road they chose dating back...
Joint isn't too tight. The end grains not being clean won't hold the adhesives used to bind them and their biscuits. Much of that is brought by...
My take after a couple of failed efforts is NOT that the wood needs to flex, but other that the joint needs to be clean for stabilization. Yes,...
Remember me for Christmas with regards to my secondary GPS, a Furuno GP37...
Maybe add one? Kidding, of course... Second the take on CMap and CMap Vector. They've treated me well. This week, however, the chart didn't...
Doing this right now. Made a jig, routing out a clean gap where the joint separation is located, filling with West System while leaving a small...
not exactly right-space-friendly.
....I have a library of Burger data in this class range, but this is not one of the boats I researched. A lot of knowledge about the boats in...
Sparkman Stephens. Hargrave all had pilot houses forward.
I was fortunate to have the time and patience to really dig into the empty shell that I bought. I was able to locate areas structurally where the...
1750 RPM 18 Knots 21 GPH 1800 RPM 18.5 Knots 22 GPH 1850 RPM 20 Knots 23 GPH 1900 RPM 21 Knots 24 GPH 1950 RPM 22 Knots 26 GPH 2000 RPM...
Yes, not only this but when you choose the units you want to use, go make a template and walk it into place from the dock before you make the...
Same user. Repowered from the DD 8's with Allisons to Cat C15 with TD. Main salon floor and all interior cabinets and walls were nidacore. Main...
