O K, you hooked me, What Dispute? If there is anybody who can pull up to a water side bar and have a dispute, it IS some of us here.
Was ALKI looking for led voltage drivers or alternator voltage regulators?
A whole Merc, Crusader, Volvo, Marine Power,,,,,. New starter, alternator, Carb or EFI equipment, manifolds, wiring harness, coupler, fuel...
Well there ya go, I think I still need to tap on ya for that coffee (cheap coffee is getting hard to find these days). Give us a heads up with...
If you already have 2.5 inch shafts in place. Smile allot and leave them alone. At 17 feet, I would think two piece shafts and a muff. Four...
AND, how long are the shafts? how many supports? 120 hp can use 1 1/4 to 1 1/2 inch if not to long.
Twin diesel trawler or fast planing hull? How much horse power are you going to load on those wheels? If your over 500 hp, 2 inch minimum, prefer...
Ahh, Understood.
On a Delco Alternator? How many you need?
Well then, the world is full of possibility's. Anything can come out, stay in, come out & in. Pushing my thoughts; I'm assuming two piece cams?...
I service St.Augustine a few times a month. Old coffee on board?
Struggled?? Different feel, boat leaned different?? hardware problems??
Was just discussing this at the shop the other day. Lenco has a good product and nobody to date can say anything real bad about them. There have...
We manage a Meridian with that set up. Owner loves it. We service it and no problems anywhere. Stay excited and stay in touch. ,rc
Hydraulic shop?? NO.. If you don't have a flair kit, any plumber can knock it out before the first beer is opened. You can just re-flair that end....
On my 12v it's a 3/8 compression fitting before the block bottom edge. Can you show us a picture? Make sure I'm (and others) are on the same...
I had a couple of bad holes where my liners fit poorly in the block (12v71s) and my shop cleaned them up (block holes) while in the boat. I'm sure...
If the crank is in good shape, usually, the block can stay in the boat. Pulling those long cam shafts may need some extra fore/aft room.
I'm guessing you went into the sump for a check out or check the rods to the wet cylinders. Large washers in the pan would come from cam gear...
I was only able to view bits & pieces of the video. The last parts when she was hauled showed it was not a hole, 30 feet of planks were Missing....
_2.jpg&contenttype=jpeg "Click for YF Listing Service")