What is the advantage of t-clamps for exhaust or water cooling lines vs regular hose clamps. I also see their are torque clamps with springs that...
K1W1, Thanks for the video its very good. Looks like even if you put the blades in reverse the pump will correct the blades with no issues. Thanks
I'm getting ready to remove and replace my engine impellers for my first time. Is there any secrets or tips on how to change these. I know to...
The engine room entry door insulation/sound barrier has deteriorated (fallen apart) and I need to replace. It's 21"x21". The exposed side looks...
Will do. Thanks again for everyone that helped.
Okay changed the sensor yesterday and everything seems to be okay. Took it out today for a short run and the starboard engine was about the same...
I know on my boat (deep vee) if I run less than 80% of my topend rpm number the boat lugs and the soot is heavy. If your top rpm number is 2850...
Yes that will happen on mine as well. Just don't touch the slave or if you do reset the sync button.
Coolant Pressure low Just got back from the Bahamas late today (Sat). 175 nm home trip 6.5 hrs. Alarm went off again about 20 nm from us...
Engine Sensor Coolant Okay I pumped up the sb eng to 10psi and will take it for a ride. After pumping up the sb engine it is now reading higher...
Good info. I had noted that when we were running 1850 rpm my coolant pressure at wp was 46 on port eng and 33 on the sb which is where the...
Coolant Pressure low Talked to Man today and they said the fresh water pump impeller is brass and it would be very unusual for it to be bad. I...
Marmot, I have found the upside down sensor and taken the wire plug lose and reconnected it with no change. Haven't loosened the sensor because...
I guess its possible since I had to have the coolant drained to replace the engine oil cooler gasket a few weeks ago on this engine. I have run...
No I have not. I was told that the coolant pressure on the water pump did not have anything to do with the impeller.
Just got to the Bahamas and having a problem. Man eng CR900 8 cyl. Alarm went off on starboard engine about 25 miles from Port Lucaya. It read...
Got one. Thx
Using the G clamp do you just clamp it right on to the shaft. If so will it hold all right?
If you lose an engine at sea and have to return on one engine what is the best way to keep the non-working shaft/prop from turning so the dripless...
On my Cabo the door latches especially the one in the cockpit and the one on the transom for the fishdoor need to have the small rubber protector...
