If it is the end cap on your "heat exchanger" they are available as replacements,
If it is...
I don't know if it is allowed to post parts source web sites on here, but sorry if not. Try here they show one priced, don't know if it is in...
I called all over for some parts for mine last summer and found the only place with those I needed was French Creek Marina. They have quite a bit...
I have a Voyager 450 and believe the vents are similar to the 53. My vents have a drain hole at the bottom of the sealant around the vent...
I cut the access hole from the engine room. What a great thing..... I can now clean the dryer vent in the combo unit easily.
I would appreciate the photo, as mine is a combo unit and my dryer vent is out of the washer. Just want an idea where the cut etc....
At 6'2" 220lbs and 63 yoa. I don't fold or spindle I only mutilate.
V&V as I call it makes me very flexible.
Glad to help and hope that is the problem. If you could, I'd like to see a photo of the access door from the engine room. That would...
This is a vented loop.
Vented Loop 5/8" Mf843
Before you take things apart, look for a vented loop in the drain hose where it runs through the space under the galley sink. I had the...
I Did the install in my 450 of a combo vented unit. If you have separates all the 1/2 round trim and both sliding doors may have to be...
My 450 also came without a hatch cover if you find someone who has or will make 2 please let me know.
I have the rail on mine as in...
High water sensor
I have a high water sensor mounted 2 inches above the stern bulkhead weep hole under the genset below the battery switch for...
I replaced 2 of the 3 last year on my 450 Voyager. Mine are 3 Rule 2000 gph.
Cummins 450 speed
Careful with the proper change. As per Tony Athens (Cummins expert at Seaboard Marine) the engines should run up...
We are back up for the summer (if it ever comes). I think Joel is going to plan a brunch.
See you soon, and stay warm.
There is a solenoid valve in the freon high side, near the compressor, that is known to stick. Tap it with a plastic hammer or...
My trans is 2 to 1.
My props are 28X24.5---3 blade with cup.
My 99 Voyager is hull 003. While working with a local prop guy my top speed is 22 knots (25.31 MPH) at 2690 rpm on my...