Wait. What? There are systems aboard? Lol...I thought recently I would take away or two and create the outline of an "owners manual" for the...
You could use the boiler system to heat your chiller water if you set it up with a heat exchanger and a separate heating loop to drive the heat...
If you're only running the one chiller, that 52 degrees basically means that your air discharge is never going to be colder than about 72 degrees,...
On areas of high water flow, like HVAC etc, I've introduced a bronze tee in line of the hose just ahead of a heat exchanger or sea strainer,...
Likely there isn't more than 4 or 5 feet of head pressure, BUT as the water line splits to feed two coils that volume doubles, increasing the...
The general rule of thumb for heat exchange in the air handlers is 20 degrees. So if your chiller water at the air handler is 52, your cabin temp...
Yeah, I can see where issues at the genny could impact voltage irregularities, but I don't see the correlation to the chillers in the manner...
My setup is also stacked. My pumps are at the bottom. #1 is roughly sitting atop the water line above them. #2 is sitting atop #1, and all raw...
I’m running two fives in series, total of 10. Loop temps run 44 to 54 on #1 and 46 to 56 on #2. Goal is to keep #2 from short cycling and only...
I try to match pumps up, be them for raw water, circulation, fuel polish, etc to share the same motor. Then it’s a matter of inventorying pump...
Heck, eBay, Grainger, whatever is convenient. The Oberdorfer units are so simple to rebuild and maintain. I just buy parts as needed. Seals,...
Right, and the Ray hub gives me that capacity, but I can see how you'd be limited. I had my initial setup installed by a vendor. It was all...
Yes, I'm a believer in redundancy as well. And I have a couple of legacy pieces still aboard for that same reason. In fact Im still running a...
I can imagine, now that I've properly read your setup, that the Fair outside of the Ray platform could be a challenge...
And same reason, in the dark I find it much easier to simply manipulate the screens as opposed to fighting a joystick only to realize I'm...
Right, missed that. I'm connected to the Raymarine Glass Bridge displays through the hubs. Could have sold you mine....lol...
Running both a M300C and a your M232...
...I ran both of my FLIR cameras to the Raynet hubs, and I can access them at every station. I have 5 screens aboard. I also have a video camera...
Ok.....so.....no, you didn't need the joystick, and I put one at both stations only to never use them.
I run 10 tons of chiller, and I'm set up with two Oberdorfer 1hp centrifugal pumps mounted just below the water line with valve controls and an...
