Or just follow the wire and see what it feeds...Ancillary Person Searching.
Whether the results are doctored or not, I haven't spent any time investigating as the RPM and speeds you're showing with your link are similar in...
This test is rather interesting to me...specifically looking at the performance comp at hull speed...Neptunus
I'd wager that considering the cost of the props, the shaft modifications would be a rounding error in the financial calculus.
That's displaying a considerable shaft-length-extension, or it's a very clever hub assembly....
You discriminate against large surveyors? Or just need a little person to get into little places?
I have an APS breaker on my 24v panel. It's the Auto Pilot Solenoid. Activate the hydraulic steering pump, and the pilot steers by solenoid.
Might also check with Marine Liquidators in Ft Pierce.
Didn't the presentation state "same blade area" moving higher quantity of water without the vortices? Am I missing something?
I'm in the cue for the props, but I'm "the other guy". I'm looking at shaving vibration and driving engine efficiency at hull speed. I'll remain...
Atlas Marine is scalable, is what I have, and does what you are seeking. I would estimate that it would begin at a level of around 100 amps of...
No doubt she's a dock queen. Perhaps a lake vessel.
What about the older-new Huckins 40 or 44?
This is what rings to my ear. Sure, it's pretty on the horizon. How the heck does the captain remain centered on that bridge while backing down...
4:30 to 4:50 sort of made me queasy...
It would have to unless a 20 foot draft with iron 10 feet below the water line...she's tall enough to be influenced by wind patterns developed by...
My experience aboard with my electric heat cylinders for the loop, I set the water temp for the loop to run around 90 degrees. In fact I think...
I went to 2 Force 10 stainless 20 gal water heaters. They’re more effective than a household 40 and need less power. Plus they have the internal...
you’d set the water heaters to maintain a specific loop temperature. The chillers would be turned off. The air handlers would do the work supplied...
Key on heat is to set the temp low. The water doesn't need to be scalding. 20 degrees is the temp delta that encourages the heat exchange to be...
