Click for Mag Bay Click for Comfort Click for Abeking Click for YF Listing Service Click for YF Listing Service

Running with only one trim tab?

Discussion in 'Stabs, Tabs & Gyros' started by RichV, Mar 14, 2021.

You need to be registered and signed in to view this content.
  1. RichV

    RichV Member

    Joined:
    Oct 26, 2020
    Messages:
    65
    Location:
    Massachusetts
    They were just re-bedded, which is one of the reasons it at Lambs. Apparently it didn't eliminate the rattle. I will be back on the boat on Thursday and plane to run it on Friday. I will check for play in the rudder arm/connecting rod.
  2. bayoubud

    bayoubud Senior Member

    Joined:
    Feb 19, 2017
    Messages:
    1,149
    Location:
    Florida
    Had a loose rudder connection I could hear making a clacking noise when the autopilot would activate while trolling, but could not hear it underway. All good after tightening.
  3. cleanslate

    cleanslate Senior Member

    Joined:
    May 29, 2018
    Messages:
    1,648
    Location:
    Cherry Hill, NJ
    Good ideas on the rudder gear.
    Well I’ll just add it to my list for my boat, to check over my 39 year old rudder stuff...I do have a mystery vibration at higher RPM . But it’s not bad enough for me to worry to much about. Been living with it for a while.
    But leaving it, things do grow into bigger problems.
  4. d_meister

    d_meister Senior Member

    Joined:
    Mar 4, 2010
    Messages:
    468
    Location:
    La Conner, WA.
    Did the yard toe-in the rudders? If they are completely parallel, they would rattle from the minor amount of slack in the rudder tie bar. Toe-in helps the boat in terms of directional stability and is commonly done.