Click for Mulder Click for Nordhavn Click for Perko Click for Glendinning Click for Furuno

Beach Launch

Discussion in 'General Yachting Discussion' started by Capt Ralph, Feb 17, 2020.

You need to be registered and signed in to view this content.
  1. Capt Ralph, Feb 17, 2020
    #1
    Capt Ralph

    Capt Ralph Senior Member

    Joined:
    Sep 8, 2004
    Messages:
    12,736
    Location:
    Satsuma, FL
    From another thread I noticed this picture;
    Princess X95.jpg
    I can only assume a beach launch with a travel lift.

    Is this a normal event in some areas?
  2. Oscarvan, Feb 17, 2020
    #2
    Oscarvan

    Oscarvan Senior Member

    Joined:
    Nov 10, 2015
    Messages:
    969
    Location:
    Chesapeake Bay
    Princess Yachts has several locations. Hard to tell exactly where that would be from the air, but I see numerous large concrete ramps going into the water in Plymouth, UK
    Last edited: Feb 17, 2020
  3. Pascal, Feb 17, 2020
    #3
    Pascal

    Pascal Senior Member

    Joined:
    Feb 29, 2008
    Messages:
    8,159
    Location:
    Miami, FL
    That’s an expensive piece of machinery to submerge ...
  4. Oscarvan, Feb 17, 2020
    #4
    Oscarvan

    Oscarvan Senior Member

    Joined:
    Nov 10, 2015
    Messages:
    969
    Location:
    Chesapeake Bay
    I suspect it's built for it....no tender parts below the water line. Hose it down when you're done. :D
  5. wdrzal, Feb 17, 2020
    #5
    wdrzal

    wdrzal Senior Member

    Joined:
    Feb 6, 2006
    Messages:
    413
    Location:
    Allegheny Mountains of Western Pa
    I seen that also , but even if it was running on concrete travel ways ,there is no benefit for the lift to come off plumb & level. I can think of quit a few possible failure scenarios if it's off plumb and level.
  6. Ward, Feb 17, 2020
    #6
    Ward

    Ward Senior Member

    Joined:
    Jan 18, 2010
    Messages:
    266
    Location:
    Vancouver BC
  7. Oscarvan, Feb 17, 2020
    #7
    Oscarvan

    Oscarvan Senior Member

    Joined:
    Nov 10, 2015
    Messages:
    969
    Location:
    Chesapeake Bay
  8. Oscarvan, Feb 17, 2020
    #8
    Oscarvan

    Oscarvan Senior Member

    Joined:
    Nov 10, 2015
    Messages:
    969
    Location:
    Chesapeake Bay
    Apparently THEY seem to be OK with doing it, and have been doing it for years. The benefit is getting it in the water.
  9. Capt Ralph, Feb 18, 2020
    #9
    Capt Ralph

    Capt Ralph Senior Member

    Joined:
    Sep 8, 2004
    Messages:
    12,736
    Location:
    Satsuma, FL
    I think you found it.
    Follow the coast up a few 100 yards and there are a few rails systems.
    Whole bunch of other funny looking docks past them including a pen full of FA Subs.
    But no syncro-lift systems or dry-docks.
    This is all interesting how these task are done at other parts of the world.
  10. Oscarvan, Feb 19, 2020
    #10
    Oscarvan

    Oscarvan Senior Member

    Joined:
    Nov 10, 2015
    Messages:
    969
    Location:
    Chesapeake Bay
    There's some good ones here:
  11. JWY, Feb 19, 2020
    #11
    JWY

    JWY Senior Member

    Joined:
    Feb 22, 2004
    Messages:
    1,513
    Location:
    Ft. Lauderdale
    Do you mean the boat?
  12. HTMO9, Feb 19, 2020
    #12
    HTMO9

    HTMO9 Senior Member

    Joined:
    Jan 13, 2009
    Messages:
    1,671
    Location:
    Germany
    The beaching travel lift of the Düsseldorf Boat Show is now on duty for 40 years and working pretty flawless.



    boot19_MK17103.jpg
    They are quite common in Europe and especially in England.
  13. Capt Ralph, Feb 19, 2020
    #13
    Capt Ralph

    Capt Ralph Senior Member

    Joined:
    Sep 8, 2004
    Messages:
    12,736
    Location:
    Satsuma, FL
    In the big pic, Telescoping outside wheels, WOW.
    Also, helper cables to shore.
    Thx HTM09
  14. Pascal, Feb 19, 2020
    #14
    Pascal

    Pascal Senior Member

    Joined:
    Feb 29, 2008
    Messages:
    8,159
    Location:
    Miami, FL
    No I mean the travel lift. Even if rinsed greased and services that s still many components going in salt water ...why not build a proper well to launch and haul out ?
  15. Oscarvan, Feb 19, 2020
    #15
    Oscarvan

    Oscarvan Senior Member

    Joined:
    Nov 10, 2015
    Messages:
    969
    Location:
    Chesapeake Bay
    I'm sure they have a reason......
  16. Capt Ralph, Feb 19, 2020
    #16
    Capt Ralph

    Capt Ralph Senior Member

    Joined:
    Sep 8, 2004
    Messages:
    12,736
    Location:
    Satsuma, FL
    One heck of a long travel well with lots of dredge maintenance. That long beach may be the obstacle and long piers are more expensive than traveler maintenance.

    I'm of the feeling the West PacRim ship launchers would luv that beach with their air noodle launch systems.
  17. Oscarvan, Feb 20, 2020
    #17
    Oscarvan

    Oscarvan Senior Member

    Joined:
    Nov 10, 2015
    Messages:
    969
    Location:
    Chesapeake Bay
    Now that you mention it..... I know a few places on the other side of the North Sea that silt in while you're having lunch. Could well be the reason.