Click for Westport Click for Mulder Click for JetForums Click for Burger Click for Delta

Hull Zincs

Discussion in 'Ocean Yacht' started by PamSails, Jul 15, 2019.

You need to be registered and signed in to view this content.
  1. PamSails, Jul 15, 2019
    #1
    PamSails

    PamSails New Member

    Joined:
    Feb 24, 2018
    Messages:
    21
    Location:
    Annapolis, MD
    Buena Ventura is looking better and better. Divers went over her bottom for cleaning and inspection. Cleaning went well and inspection showed the propellers no longer had pins holding them on tight. And, no zincs. Divers are adding prop shaft zincs and on the trim tabs. The question is what zinc was used on the hull. They found a single, centerline, hole where a zinc should go. Was the original design of the 1983 46 Sunliner/SS a zinc with one hole?

    You can see how BV is coming along in my YouTube channel Buena Ventura Life.
  2. 45SS, Jul 16, 2019
    #2
    45SS

    45SS Member

    Joined:
    Sep 12, 2018
    Messages:
    34
    Location:
    New Jersey
    I forget the part number but yes, single hole, about 9 or 10 inches long by about 4 inches.
  3. PamSails, Jul 16, 2019
    #3
    PamSails

    PamSails New Member

    Joined:
    Feb 24, 2018
    Messages:
    21
    Location:
    Annapolis, MD
    Thank you. I told the divers so they can get one for the hull. Life is good knowing I have working engines and two props! And now zincs!