Click for Perko Click for Cross Click for YF Listing Service Click for MotorCheck Click for Nordhavn

Thoughts on sandblasting my wheels

Discussion in 'Props, Shafts & Seals' started by tbaxl, Nov 22, 2020.

You need to be registered and signed in to view this content.
  1. tbaxl

    tbaxl Member

    Joined:
    Jun 18, 2020
    Messages:
    49
    Location:
    Gulf Coast
    Wheels are off for cutlass bearing change so it is time to re do my antifouling. I am 99% sure they do not need to be checked as there have been zero issues felt and they look perfect with exception of the prop speed. Can I sandblast them to clean the up or is that a bad idea.
    Tim
  2. MBevins

    MBevins Senior Member

    Joined:
    May 23, 2008
    Messages:
    1,162
    Location:
    Windsor On. Canada
    My initial reaction is no it's not a good idea. I suspect you'll damage the edges.
  3. tbaxl

    tbaxl Member

    Joined:
    Jun 18, 2020
    Messages:
    49
    Location:
    Gulf Coast
    Not really worried about edge damage as much as heat and warping. Have already decided I will just chemically strip and hand sand.
  4. Norseman

    Norseman Senior Member

    Joined:
    Feb 24, 2005
    Messages:
    2,905
    Location:
    Ft. Lauderdale
    Soda blasting may be an option?
    Had my bottom soda blasted 2 years ago, gentle on the gelcoat.
    (I should specify, the Boat’s bottom was soda blasted, not mine) :cool:
  5. MBevins

    MBevins Senior Member

    Joined:
    May 23, 2008
    Messages:
    1,162
    Location:
    Windsor On. Canada
    You are correct, I was referring to warping when I mentioned the edges, just didn't clearly state that.
  6. rtrafford

    rtrafford Senior Member

    Joined:
    Jul 13, 2019
    Messages:
    1,579
    Location:
    Vero Beach
    The prop shop will sandblast them when you drop them off for repair. Sandblasting is fine if you're careful. Soda is safer.
  7. Fishtigua

    Fishtigua Senior Member

    Joined:
    Jul 20, 2007
    Messages:
    2,937
    Location:
    Guernsey/Antigua
    As above, Soda blasting.
  8. CaptTom

    CaptTom Senior Member

    Joined:
    Jan 26, 2006
    Messages:
    1,949
    Location:
    Palm Beach to Ft Lauderdale
    Would a wire wheel on a drill work? I've seen some shops do it that way before antifoul paint.