Click for Burger Click for Glendinning Click for JetForums Click for Mulder Click for Delta

Fiberglass or Aluminium Tender RIB?

Discussion in 'Tenders & Dinghies' started by Ron Cardoza, May 18, 2019.

  1. Ron Cardoza

    Ron Cardoza Member

    Joined:
    Jul 26, 2018
    Messages:
    74
    Location:
    Fort Lauderdale
    Hi,

    I'm looking at getting either a Walker Bay generation 11 LTE which allows for a 30hp engine and is made out of fiberglass bottom or a Highfield 360 CL Delux (new one is beautiful with diamond upholstery) which allows for 40 hp engine but is made out of aluminium. Both Hypolon RIB. Anyone with experience with either fiberglass vs aluminium?

    Also like the Zodiacs 360's which also allows for a 40hp.

    Thanks!
    Last edited by a moderator: May 19, 2019
  2. Ron Cardoza

    Ron Cardoza Member

    Joined:
    Jul 26, 2018
    Messages:
    74
    Location:
    Fort Lauderdale
    sorry here's low res pics

    Attached Files:

  3. Pascal

    Pascal Senior Member

    Joined:
    Feb 29, 2008
    Messages:
    8,120
    Location:
    Miami, FL
    That wide black vinyl is going to Be very painful in the sun... WB diamond patterns use black edges not on the seating surface.


    And personally I hate the raised helm seat, sooner or later a phone,towel etc will end up in the drink
  4. PacBlue

    PacBlue Senior Member

    Joined:
    Jan 9, 2009
    Messages:
    1,988
    Location:
    Dana Point, Ca
    As far as the diamond upholstery goes, it looks like a pain in the a— to keep clean, too many nooks and crannies to take care of. An over designed detail for sure.
  5. Pascal

    Pascal Senior Member

    Joined:
    Feb 29, 2008
    Messages:
    8,120
    Location:
    Miami, FL
    It a not bad. Our WB 450 has it, gets a lot of use and no worst than other vinyl
  6. Ron Cardoza

    Ron Cardoza Member

    Joined:
    Jul 26, 2018
    Messages:
    74
    Location:
    Fort Lauderdale
    I never thought of the black vinyl. Good point. would it really get that hot? as for the raised helm seat. are you talking about the high field or the 11 LTE as they both are raised?
  7. Ron Cardoza

    Ron Cardoza Member

    Joined:
    Jul 26, 2018
    Messages:
    74
    Location:
    Fort Lauderdale
    good point. do you think it would depend on the stitching thou?
  8. Ron Cardoza

    Ron Cardoza Member

    Joined:
    Jul 26, 2018
    Messages:
    74
    Location:
    Fort Lauderdale
    I think the difference here Pascal after looking at your 450 is that the size of the diamonds on your boat are much larger and might be easier to maintain as there would be less of areas that dirt, oils, etc can settle into and also the stitching I believe might make a difference.