Click for Cross Click for Mulder Click for Burger Click for Glendinning Click for JetForums

Fighting Chair base

Discussion in 'Post Yacht' started by jerry bredow, Jan 8, 2019.

You need to be registered and signed in to view this content.
  1. jerry bredow, Jan 8, 2019
    #1
    jerry bredow

    jerry bredow Member

    Joined:
    Mar 30, 2015
    Messages:
    37
    Location:
    Longport, NJ
    When I purchased my 1998 47' Post, it was missing the fighting chair. I am a cruiser and not so much a fisherman. I am looking to put a table in the cockpit where the fighting chair was. Has anyone done this and or know the pedestal base size?
  2. Beau, Jan 8, 2019
    #2
    Beau

    Beau Senior Member

    Joined:
    Jan 15, 2010
    Messages:
    2,261
    Location:
    Beaufort, NC
    I believe your fighting chair was probably from an outside vendor and not specific to Post. Any label on the deck plate? Can you measure the hole size? You probably can purchase a pedestal table that will fit right. Try a net search eg Arrigoni in CT. I may be spelling that incorrectly. But they have some nice teak applications reasonably priced.

    Also, if there was a chair installed at one point that probably means the cockpit was reinforced in that area - check that.
    Last edited: Jan 8, 2019
  3. C team, Jan 9, 2019
    #3
    C team

    C team Senior Member

    Joined:
    Nov 1, 2011
    Messages:
    244
    Location:
    Kent Island
    I second the suggestion of contacting Arrigoni. The make/sell cockpit tables that I'm sure could be costumed to fit the fighting chair base.

    I purchased a high/low table from them years ago. They are a bit pricey but make quality stuff. They also go to all the major boat shows.

    https://www.arrigonidesign.com/tables/cockpit-tables/