Click for Northern Lights Click for JetForums Click for Cross Click for Delta Click for Glendinning

1984 Post Marine 43 A/C drain line

Discussion in 'Post Yacht' started by Robert W, Jul 12, 2018.

You need to be registered and signed in to view this content.
  1. Robert W

    Robert W New Member

    Joined:
    Jul 12, 2018
    Messages:
    1
    Location:
    Livingston, TX
    I have a Post Marine Convertible and I can not find the a/c drain lines nor can I find any information for them in my manual. Can anyone help me and tell where they may be and how I can get to them to clean them out. Thanks guys. I am new to the forum so any help would be great.
  2. YachtForums

    YachtForums Administrator

    Joined:
    Dec 22, 2002
    Messages:
    20,378
    Location:
    South Florida
  3. Davidoc

    Davidoc Senior Member

    Joined:
    Aug 29, 2005
    Messages:
    242
    Location:
    Winter:Delray Beach, Fl Summer: Bahamas
    What year is your Post and what is the layout of the AC units? Where are the intake or return vents?
  4. Capt J

    Capt J Senior Member

    Joined:
    Jul 11, 2005
    Messages:
    14,435
    Location:
    Fort Lauderdale
    Find your return a/c vents in each room. The a/c unit will not be very far from the return vents.
  5. mwwhit1

    mwwhit1 Senior Member

    Joined:
    Jan 19, 2006
    Messages:
    239
    Location:
    Jersey City NJ\Boca Raton FL
    I have the same boat\year. In the forward cabin, open the starboard smaller closet door. The AC unit is in the top of this cabinet and the drain line goes down the corner of the cabinet, into the bilge PVC connector tube, and into the shower sump under the galley floor.
    For the salon unit, remove the small ceiling panel above the side room upper bunk. You will see the drain hose with a "T" to the side room AC unit. This hose goes into the engine room and connects to the seawater outlet for the AC pump.

    Cleaning the actual AC drip pan is pretty much not possible. I blew backwards in the drain line and poured some water into the coil area. This gets most of the debris out.