Is this alarm the same one as when you turn the ignition on, your Check Engine alarm? This alarm is the Low Oil Pressure and Hot Water Temp....
A stuck helm station can be caused by "stuck" NRVs (non return valve). This valve takes either helm pressures and directs it to the steering...
First, test for fuel OR ignition problem...not assume. When the engine slows, spray starter fluid or gas into the carb (remove filter). If it...
What are your LEDs doing, at Start and Run?? If the same as a Kohler 7.3E: In the control box, relay K5 inputs the safety switches (SS) and is...
Other marine/RV 115VAC refrigs ALSO REQUIRE 12vdc to work (for the control panel), you must feed 12v to work. Do you have an AC compressor and DC...
The fiberglassed decks I have repaired used the wrong resin (polyester), and wrong glass (WR). The glass is only to make the skin strong, not...
Often the resistor is only in the "run" circuit, so the engine will start, but stop when the key is released. But Crusaders often keep the...
Test of Safety Switches Was that loose screw on the Stop switch, because only the Stop switch carries electricity when running. A bad connection...
You said your gen stopped running, and "wanted to start"....meaning it was cranking. The relay your replaced on the controller was K1, Start...
What is the make/model of your generator?
Check Electric Choke If your generator is the same as a 6.5CZ, then you have an electric choke (solinoid) controlled by a ThermoSwitch and Hot...
Need Wiring Diagram Buy an engine manual with wiring diagram and make available. From the Parts Diagram, I find 3 relays for Start: #2 a hvy duty...
Repair Sequence 1. Confirm ignition is good: Use Starter Spray (or fuel) into throat of carb. If it fires up...ignition, relays, and most safety...
I have a pdf for 6.5cz but how to send?? It is somewhere online.
First check if fuel is entering the engine. Remove filter (FA), open choke, and spray starter fluid while cranking. Wear glasses, gloves, have...
Sounds like a bad connection between your engine "Hi temp and Low Oil Pressure" warning sensors. Find the connector the 2 wires plug into near the...
Does it start? Check for power at helm engine harness. Your battery 12v goes to the starter, and then feeds the power throught an in line fuse AND...
If you're going to lift 1200 lbs with an 800 lb. hoist...then identify the areas of stress....what's going to bend or break? Add bolts to the...
I was seeking experiences of solo cruising. I should have asked what safety precautions can be taken when one makes "solo" day trips in a boat he...
How safe is it to operate a yacht SOLO??