Click for JetForums Click for Abeking Click for Mulder Click for Delta Click for Nordhavn

Seperating coupler from shaft

Discussion in 'Technical Discussion' started by Beau, Oct 12, 2014.

You need to be registered and signed in to view this content.
Page 2 of 2
  1. Capt Ralph, Oct 12, 2014
    #21
    Capt Ralph

    Capt Ralph Senior Member

    Joined:
    Sep 8, 2004
    Messages:
    12,726
    Location:
    Satsuma, FL
    That whole coupler around the shaft is going to need to get hot. If your pulling the shaft for service, you're going to send the coupler for cleaning up anyway. May as well include the clutch flange and new rear seal. Heck you're there, do it all rite.
  2. Beau, Oct 12, 2014
    #22
    Beau

    Beau Senior Member

    Joined:
    Jan 15, 2010
    Messages:
    2,261
    Location:
    Beaufort, NC
    I got into this mess in order to change out my dripless logs! The 10 bolts that attach the flanges are good sized. Will be getting longer ones with a nice heavy plate to try the above suggestions. dsharp, you are exactly correct, my blue tip really couldn't get any good heat distribution. I'll have to wait for another weekend, my day job awaits ....
    Last edited: Oct 12, 2014
  3. Capt Ralph, Oct 13, 2014
    #23
    Capt Ralph

    Capt Ralph Senior Member

    Joined:
    Sep 8, 2004
    Messages:
    12,726
    Location:
    Satsuma, FL
    Keep us up on how it turns out.
    ,rc
  4. leeky, Oct 13, 2014
    #24
    leeky

    leeky Senior Member

    Joined:
    Jan 2, 2011
    Messages:
    381
    Location:
    Florida
    dsharp said: ↑
    I think he means a chunk of metal, like pig iron

    Thanks, dsharp and rcrapps.
  5. Beau, Oct 16, 2014
    #25
    Beau

    Beau Senior Member

    Joined:
    Jan 15, 2010
    Messages:
    2,261
    Location:
    Beaufort, NC
    Guys, Thank you enormously for your advice. I made up a steel plate to match the coupler flange, welded a "plug" to the center that extended thru the shaft nut to the back of the shaft. Bolted her up, cranked on the nuts and bam! the couplers are off. Bathed in penetrating oil, no heat, and a few raps with the hammer. I'll leave my 10 ton porta pump home next time! Thanks again. Wouldn't think about doing this kind of repair in the water...
  6. Capt J, Oct 18, 2014
    #26
    Capt J

    Capt J Senior Member

    Joined:
    Jul 11, 2005
    Messages:
    14,434
    Location:
    Fort Lauderdale
    Good to hear you do it all apart. Sometimes it's the way you do it, not necessarily the force in which you do it.....
Page 2 of 2