Just wondering if anyone has an opinion about the S/K 14 in a 78000# 54 Sportfish.
I was wondering about that myself. Somebody here knows!
I'm not seeing any comments on Zipwake performance. Has anybody run them on a larger boat?
A company named Rochester Gauges in Texas manufactures that float unit. My Bertram has a custom water tank with a side mounted sender float style...
Hey Capt, I don't know what you are exactly trying to do. As I recall you have 12-71s, One of the advertisers here has some really nice...
What was it?
Look at a well cared for Californian or Navigator. Exactly what you want.
Heat exchanger leak? Raw water into the freshwater cooling side will fill up the coolant overflow bottles
I like my 92s
Found a mixer on the east coast. Thanks
I sure wish my mixers would last like that! The original cast Iron mixer was rusted and broken and needed replacement at 950 hours. I don't know...
Thanks, Capt. J. Apparently there is a major shortage of those mixers. I have one on back order, but no advice as to delivery! I will give...
Can anybody point me toward a replacement "stainless" exhaust mixer to fit a Northern Lights LUGGER Model M753K.3 SN 7532-32218C genset. Thanks...
My interior decorator (the boss) uses non damaging adhesive strips. I believe they are called Command hangers they are easy release and are...
If you want to see these engines in a dyno pull. Check them out on u tube. The 1000hp C 18 Cat had brute torque, the 1000hp man not so much....
Bearzgirl , ReRead, what Captain J said about the screen in the line below the reservoir being plugged, if that is not it, not replace the slave....
The only reason I know anything about Hynautic is because I just recently went thru the same learning process that you are going through. 1. The...
Capt J is correct in referring to what I had called the slave, is actually called the actuator. I believe Capt J has previously commented on...
Yes, you still have air in the system. Don't be afraid to work the throttle between bleeding sessions to work out any air. You should bleed all...
To answer your question, the inside does not have to be coated. Brand new they were raw castings. I suppose it wouldn't hurt anything to have it...