I have a 98 Mariner. Found a leak coming from above the sliding door. The water would follow top, run down to where the top connects and then run...
I have a 1998 Mariner. It always takes research to find this stuff. I usually start with Bret. Bret Temple (BTemple at genmaryachtgroup dot com)...
Ok, I was lucky, no breakage. I went to Home Depot and picked up the pink RV Antifreeze and poured it in. Then opened all faucets until it came out.
Thanks, I'm going to do that. Checked on it and found some water in the bilge. I assume something broke. Not much water so maybe it was one pipe.
Sunday, made an effort to drain raw water from both engines in my 98 Mariner 350. To include the raw water strainers and any left over water in...
Update Turns out there was some "Custom" wiring. Not a bad job and it seemed to have worked but wasn’t ABYC standard and was overcharging. The...
Thanks for the information!! I fixed the shower. There were calcium deposit blocking the hot water inlet to the shower faucet. Clean both hot and...
Learning more about my 98 Mariner 350. I’ll be purchasing the manuals very soon...tired of guessing, but until then I have a question. I noticed...
I have a 98 Carver Mariner 350. Two 454lxi's with V drives. Wondering if anyone out there with the same setup happens to know what the GPH is? I...
K1W1, thanks for the "How to" adding that to my book. Highlander, excellent question...no problems with hot or cold from the galley and Head...
Finally turned on the shower to see if it works, it does but…. Cold water has plenty of pressure and the pump sounds fine. It fluctuates between...
I'll drain them a couple weeks from now in to glass jar and see what happens.
When I purchased the boat both tanks were at empty, I've filled them with new gas and had her running at 3600 for two hours straight then changed...
Capt J asked "What was in the old fuel filters? Was there a lot of white murky looking stuff?". What would this be an indication of, water in...
K1W1 –Thank you for the site. I printed it and placed it in my maintenance book. If I had “Binged” it myself then that would lead to a boring...
My new boat has Racor 110A. I need to change the elements. Anyone know of a web site that may have the instructions...or maybe you know? To...
I would have to agree about using the elements to my advantage in the 24fter. I was stressing the part about going though the Ballard locks not...
Just moved my '98 35ft Mariner from Seattle to Everett. No problems, engines purred along and this time I didn’t have to slow down for others...
Stuck with the 6 volt 8 Interstate batteries...didn't want to rock the boat.:) Electrical guy went through and fixed all the electrical issues....